Got it, continue to print. Turn over the head assembly. Self Test Release the feed button after the printer beeps 3 times. The strip bracket bar is used for strip function. Setting Up Your Printer 2.

Uploader: Nikojar
Date Added: 27 July 2012
File Size: 29.63 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 99858
Price: Free* [*Free Regsitration Required]

Only when the separated label has been taken away, will another label be printed automatically.

To print the manual completely, please, download it. Setting Up Your Printer 2. The paper jam may cause the cutter work improperly, power off the printer.

Godex EZ-4TT Plus Manuals

Maintenance And Adjustments 3. Stripper Stripper Peeler helps you separate the printed label from the liner backing paper. Number of data bits 7 or 8 p4: Cleaning the Printhead Open the Front cover and back cover.

Adjusting the Printhead Pressure Screws decrease pressure increase pressure When opening the front cover, you can see two screws on the top of the printhead assembly. Press the printer locks part 12 to loosen the printhead assembly, and turn over the head assembly. Release the feed button after the printer beeps 3 times. This manual also for: Page of 17 Go. Self Test Release the feed button after the printer beeps 3 times. Open the front cover and back cover.


By pressing ‘print’ button you will print only current page. Put back the printhead and fasten it. Loading Label Roll Fig. Enter text from picture: Use a soft cloth soaked with isopropyl alcohol to remove the stuck label and cleans the surface. Wait for about 3 seconds; the printer will print the following contents.

Godex EZ-4TT Plus Manuals

If you need any help in installation and maintenance, please consult your supplier or dealer. These limits are designed to provide gldex protection against harmful interference when the equipment is operated in a commercial environment.

Disable the Self-test, please power off the printer at least 2 seconds, than power on again. Refer described on page 5.

In case of non heat-sensitive paper, a suitable thermal transfer ribbon must be used. Whatever media in goex, the recommended minimum label height is 20 mm. Vertically place the two stands along the left side and right side of the back cover see Fig.


Remove the label roll stands ez-4tf Perform a Label Gap Sensor Adjustment as described on page Turn over the head assembly. Don’t show me this message again. Adjusting The Printhead Pressure Screws Printing stops and LED turns Software setting or programming problem.

Don’t have an account? Maintenance and Adjustments

Author: admin